Commercial Electric 16508 Instruction Manual download pdf (Page 7)

MOC.TOPEDEMOH 7

.ecnatsissa rehtruf rof 3130-725-778-1 tcatnoc esaelP

There are two installation options to choose from:

□ 3A Tape method: Remove the protective tape from the adhesive back of strip. On a clean and dry surface, place the LED strip (B)

into the desired position and press to ensure proper adhesion to the surface. This method is suitable for indoor applications and

can be used for temporary positioning outdoors in conjunction with method 3B.

□

3B Clip and screw method: Place the LED strip (B) in the desired position. Use the clips (BB) and screws (AA) to secure the LED

strip (B) as shown. Clips (BB) should be placed in open areas of the strip. Do not cover the LED lights.

NOTE :

An additional 18 foot strip may be linked to the original to create a 36 foot strip.

a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner

while placing the strip in a concave position. (Angle 90 )

b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner

while placing the strip in a concave position. (Angle 60 )

c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner

while placing the strip in a convex position. (Angle 60 ) In the convex position the

angle should not reach 90 degrees. See above diagram.

Note :

LED Chip

Correct lncorrect lncorrect

Angle 90

Angle 60

Installation (continued)

Installing the LED strip

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

No comments

Commercial Electric 16508 Instruction Manual Page 7