Commercial Electric 21353KIT-BK Instruction Manual download pdf (Page 6)

Installation

–

Surface Mounting (continued)

Installing the connection box

Installing the connection boxInstalling the connection box

Installing the connection box

Securing the cords

Securing the cordsSecuring the cords

Securing the cords

□

Attach the connection box (D) to the side of the

cabinet using two mounting screws (AA).

□

Connect the wire from the LED puck assembly (A)

and power cord with switch (C) to the hole in

connection box (D) as shown.

□

Connect the driver (E) to the cord.

□

Use nail-on fasteners (BB) to attach the wire on

the cabinet.

Installation

–

Recessed

Mounting

Preparing the lights for the

Preparing the lights for the Preparing the lights for the

Preparing the lights for the

first time

first timefirst time

first time

Inserting the LED lights

Inserting the LED lightsInserting the LED lights

Inserting the LED lights

□

Separate the trim ring (B) that is attached to the

single-cord LED assembly (A) by pushing on the

back of the LED module through the trim ring (B).

Repeat this step for the remaining LED

assemblies you wish to install and set the trim

rings aside.

IMPORTANT

: :

: Ensure that you measure the distance

of every LED puck assembly (A) before drilling the

installation holes. The minimum distance between every

LED (A) must be at least 12 in.

□ Drill a 2.64 in. round hole into the installation

area.

□

Thread the wire from the LED puck assembly (A)

through the hole and insert the fixture into the

hole.

□

Repeat steps 1 and 2 for the remaining two LED

puck lights (A).

□

Install the connection box (D) and secure the

cords as described in Steps 5 and 6 in the

Installation – Surface Mounting section.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Commercial Electric 21353KIT-BK Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown Commercial Electric 21353KIT-BK