Commercial Electric ESS8113-3 Instruction Manual download pdf (Page 4)

Page 4

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

1ea Canopy (#1) 1ea Screw Collar Loop (#2) 6 feet Chain (#3) 1ea Ring (#4)

1ea Loop (#5) 6ea Lock Nuts (#7, #13) 3ea Screws (#8) 3ea Socket Rings (#16) 3ea Shades (#17)

3ea Curve Arms A (#9)

ASSEMBLY INSTRUCTIONS:

1. Carefully unpack the fixture. Lay out all parts on a clean surface.

2. Screw the Loop (#5) onto Nipple A (#6). Use pliers and a screwdriver to twist open the link

(cover the chain with cloth to prevent damage to the link finish) at the end of the Chain (#3)

not attached to the Screw Collar Loop (#2). To avoid damage to the link, only open the link

enough to hook it onto the Loop (#5). Hook the open link to the Loop (#5) and then close

the link.

3. Screw the Tube (#10) onto Nipple B (#14).

4. Place the hole located on the bottom of Curve Arm A (#9) onto Screw (#11) on Curve Arm B

(#12), and secure Curve Arm A (#9) by screwing the Lock Nut (#13) onto the Screw (#11).

Place the Screw (#8) located on the top of Curve Arm A (#9) into the hole located on the

Cup (#19), and secure Curve Arm A (#9) by screwing the Lock Nut (#7) onto the Screw (#8).

Repeat for the other two Curve Arms A (#9).

5. Weave the fixture wires up through the Chain (#3), through the Ring (#4), through the Screw

Collar Loop (#2), through the Canopy (#1), and through the Nipple (#25 on Page 7) on the

Mounting Strap (#24 on Page 7). Screw the Nipple (#25) into the Screw Collar Loop (#2).

6. Unscrew the Socket Rings (#16) from the Sockets (#18). Place the Shades (#17) over the

Sockets (#18). Screw the Socket Rings (#16) onto the Sockets (#18) to secure the Shades

(#17).

7. Install three 60 watt medium base incandescent light Bulbs (#15) (not included) or three

equivalent standard base compact fluorescent light bulbs (not included) in the three Sockets

(#18) in the fixture.

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Commercial Electric ESS8113-3 Instruction Manual Page 4